EN CN
YAW drifts away by moving PITCH via RC
-
I have the 32-bit controller and the latest firmware (b7). It works perfectly but I have one little problem. When I move the PITCH-axis via remote control, the YAW-axis drifts slightly away. Movig the camera upward the gimbal rotates to one direction, movig it downwards rotates it to the other direction.
-
Likely calibration problem or IMU installation problem. The IMU axis should be as close same direction as gimbal axis. (and gimbal axis need to be as accurately 90 degrees to each other.)
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!