Hi I have two CM3000's one on a Phantom (older cm3000 with 8 balls)
And a second one on a new Hex FlyPro x600 (new model cm3000 with only 4 balls)
The unit on the phantom works great....
But the second one on the hex has a small annoying issue....
The camera will tilt forward maybe 5-10 degrees at times, usually at the end of a straight run as stopping.
I have never noticed this with any of the other Arris gimbals I have used.
Any suggestions or direction with the problem would be sincerely appreciated....
Many thanks in advance!