LukeMaximoBell

Motor is Missing Steps
It turned out that my D gain for the yaw was actually just too low! I lowered the P and raised the D and now it's working.

Comment by LukeMaximoBell August 2016 permalink
GUI not allowing me to select the frame sensor for calibration
Did you turn on the frame IMU in the Advanced tab? Sounds like you didn't activate it, so it doesn't know there is a frame IMU connected.

Comment by LukeMaximoBell September 2015 permalink
Blue Acceleromoter axis stuck in the IMU calibration helper
It is the IMU that came with the board because it is an onboard one. So I can't even replace it now.

Comment by LukeMaximoBell September 2015 permalink
Blue Acceleromoter axis stuck in the IMU calibration helper
The GUI picks up both of the IMUs. The problem is that the z-axis of the acceleromter of the onboard IMU doesn't work at all. It stays at the same value. I got it from Flyduino. Don't buy stuff from them. Their customer service is pathetic.

Comment by LukeMaximoBell September 2015 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In Apply for Membership

About

Username: LukeMaximoBell
Joined: April 2015
Visits: 2
Last Active: August 2016
Roles: Member

Powered by Vanilla