basdebeer

Procedure of encoders calibration
I see the angle for the EL.Field offset can be changed. Why is this and what improvement does a bigger angle make for the calibration?

Comment by basdebeer February 2022 permalink
Yaw encoder problem
I think I have this problem as well, all works well unless I pan the yaw motor beyond 10 degrees both directions. Power use gos to max and torque dissipates. I will try a different magnet or non ferro screws.

Comment by basdebeer February 2022 permalink
Gimbal is stable during tuning but going crazy during flight
I have the DYS smart 3 gimbal and have the exact same problem! especially yaw gets crazy in air.

Comment by basdebeer May 2015 permalink
ROLL problem (and a weird pitch motor)!!!!!
hey, Here are some videos which show the problems and vibration. The gains are not good, I know, but I did a full reset to see wether that would make a change, too bad. I hope someone can recognize the problem in the videos and tell me what I need …

Comment by basdebeer September 2014 permalink
ROLL problem (and a weird pitch motor)!!!!!
The roll cage is only supported on the motor but its not able to flex or twist. My camera is not too heavy so that wont be the problem, as soon as I get home I will send some pictures or upload a video, if that would make it clear.

Comment by basdebeer September 2014 permalink
ROLL problem (and a weird pitch motor)!!!!!
Well it didnt work because the roll motor would bend of the weight. The new motors are all ok, the yaw works fine and if I swap them its still the roll motor. I also got the right poles in the gui

Comment by basdebeer September 2014 permalink
ROLL problem (and a weird pitch motor)!!!!!
oh and I also got the newest b7 software

Comment by basdebeer September 2014 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

About

Username: basdebeer
Joined: September 2014
Visits: 8
Last Active: February 2022
Roles: Member