Gimbal fully balanced and tuned reasonably well, get some high frequency buzz (in the frame) occasionally from the tilt motor. V 2.30b5
I have seen this roll when using follow yaw discussed and dbeaty solved by adjusting PID, I have now been adjusting for a while and nothing seems to stop it. Basically as soon as you rotate away from the 'home' position in yaw the roll will move a few degrees and remain, then moving back to 'home' yaw orientation puts it back to level, vice versa both directions.
I had previously not had this problem on yaw, only something must have changed but I don't know what.
May go back to absolute basics and start again, including full imu calibration, but it's a pain to remove and replace!
Thanks, yes I saw this, but I have disconnected my joystick and removed the settings in the GUI. So not sure what is happening. I may reconnect the joystick and see what happens. too tired right now! need sleep. Have to have the rig ready the day after tomorrow for a shoot!
First - new firmware 2.40b6 - the stabilization is really better. I have perfect results with new firmware and I'm satisfied with it. Good Job Alex.
When I just do yaw, roll and small tilt everything is perfect. But when I put camera tilt to 90 degrees and back then I do yaw sometimes roll is not straight . I did 6 point callibration and same result. When I'm turning yaw 360 degrees in some angle is roll skewed to right and other angle roll skewed to left. I did something wrong? How can I test if my calibration is ok?