EN CN
Error Message
  • YvesP
    Hi

    My configuration
    Ver de la carte 3.6
    Ver Firmware 2.70 b0.API V2
    Ver GUI 2.70 b0
    Only 1 IMU

    Error message on connexion
    - Error reading profile 2 Systèm setting are corrupted in the Eprom Write correct values and resart the controlleur
    - Error reading profile 3 Systèm setting are corrupted in the Eprom Write correct values and resart the controlleur
    - Error reading profile 4 Systèm setting are corrupted in the Eprom Write correct values and resart the controlleur

    Impossible ti calibrate système "CALIB_ACC" don't work

    Thanks for help
  • AlexDeSalta
    I have the same problem, the backup does not work either and the gimbal was unusable.

    I sent an email to IKAN requesting the factory profiles but they never responded.

    I used a profile that I found here and it improved a lot but it doesn't work properly.
  • silverarrow111
    i have upgraded the firmware my controller(sbgc3.6) to ver2.70b0 and it worked fine before upgrading, the error is showing the corrupted serial data with continuous blinking of the green light
Add a Comment