EN CN
G10060 BGC PRO
  • bit
    Would this motor work on basecam pro board?

    It have 3 ohm phase to phase and 60 poles.

    How would this motor run on basecam pro board and is it possible?

    url: https://www.aliexpress.com/item/32944245255.html

    -bit
  • AndrewSupport
    Hello,
    Your link doesn't contain any technical data which required for prediction of the compatibility of the motor with our controllers.
    But the motor looks like a motor from this manufacturer: http://shop.smc-powers.com/PM12060-GB
    The motor on my link is compatible with Pro and CAN_drv controllers.
  • bit
    Ok thanks för the information.

    But 60 poles motor will works fine with pro controller? How about cogging effect? Any other negative effects regarding pole count?

    Best regards

    /bit
Add a Comment