EN CN
SBGC v3.0 and encoders
-
Hi
I have SBGC v3.0 how i can connect the encoders to the controller?
Because in instruction nobody show this controller.
The instruction ""solder the jumper to supply 5V for encoders""
http://tinypic.com/view.php?pic=9un98h&s=8#.VZsxSmAUpSU
http://tinypic.com/view.php?pic=2gx1yjm&s=8#.VZsxrmAUpSU
What I can do?
-
If you're sure that it's the jumper, then yes. Bridge the gap with solder and it will power the right side of the board with 5 volts.
-
So o.k I mesure it
I will be happy if somebody tell me is that's o.k or not.
1 ( + and right side)
http://tinypic.com/view.php?pic=2njw0eg&s=8#.VZ2v6mAUpSU
2 ( + and left side)
http://tinypic.com/view.php?pic=v6t5s9&s=8#.VZ2weGAUpSU
3 ( right and left )
http://tinypic.com/view.php?pic=rs93yt&s=8#.VZ2w0GAUpSU -
Hi
quick question... where should I plug yaw encoder? to RC_PITCH?
http://tinypic.com/view.php?pic=ok4dp3&s=9#.Wa2gRMY1RE4 -
Hello,
Yes, YAW encoder should be connected to RC_PITCH: http://ybex.com/d/t2fy37gtdck1vsd59tjxpme9sijlboageo5yo6tg.html -
O.k Thank You.
I still have a problem .... when i move only motor Pitch the pitch arrow on the GUI panel move up and down (o.k) the bar Roll(GUI) move together with Pitch but it should be still !Someone knows where the problem is??? Please help. -
I think it's time for someone to do a specific SBGC tutorial because it's really not that easy :(
-
Hello, I have a B32 gimbal controller and I have the problem that it does not turn on, I do not know which GUI to use and the ones I use only tell me which port is connected, it does not say version, much less firmware, nor does DEVICE SN tell me if someone can help me
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!