EN CN
Update from 2.43b9 to 2.50b2
  • tompa
    After firmware update from 2.43b9 to 2.50b2 I have problems with yaw axes in follow mode- when doing fast movements, after stopping, the yaw axis gimbal sometimes "escape".
  • kikojiu
    I have the same problem. No control over the 3rd axis
  • alexmosalexmos
    Can you show a video of this problem?
  • tompa
    I have changed the PID value and now is better. On my gimbal manifested as sometimes overshooting and sometimes trembling in the target position (followed by high sound from yaw motor). Now have not overshooting but yaw axes motor sometimes tremble and "playing" high sound. It is strange that it happened after update.
  • kikojiu
    I discovered it was the LPF... :-) Problem solved.
Add a Comment