ARMBGC 32bit burned

stpfl

Hi!

i connected brand new Arm Alex Mos 4.0 with 6S Lipo. 3 seconds nothing happened then it burned.
I connected it with the right polarity.
I am not sure what i did wrong - i guess the controller must be defective right out of the box.
I will send the defective controller back because it seems to me its was defective.

stpfl

https://dl.dropboxusercontent.com/u/53587498/burntarmbgc.jpg

Same with another customer!

http://forum.basecamelectronics.com/index.php?p=/discussion/776/voltage-error-on-the-armbgc-v-4-0-32-bit-alexmos

AOPEN3434

I do not thinks the board supports 6S 22V think 4S 14 volts is the max voltige

MShekunov

Full 6S is 25.2V
This board support up to 25V.

Please, contact the seller to solve the problem.

theflamez

According to the datasheet of this component it supports voltages up to 24V.

stpfl

I tested with a half charged battery pack - so voltage was below 25V !
As i told this User burned the same component even with 4S Lipo!

http://forum.basecamelectronics.com/index.php?p=/discussion/776/voltage-error-on-the-armbgc-v-4-0-32-bit-alexmos

stpfl

i still get no board from ARM BGC. I sent the board in April 10
It seems ARM BGC did not know by hisselft if they shippid it already

stpfl

http://forum.basecamelectronics.com/index.php?p=/discussion/933/arm-bgc-bad-support

Howdy, Stranger!

Categories