I have armbgc v3 (red one) board and I am trying to make the follow mode work, I have tried different settings on different axis - no change, the follow mode just doesn't work, I tried that on 2.0b3, b4 and 2.1 versions
I also have an armbgc v3 broad with latest firmware v2.1, but the follow mode just doesn't work too. Please show me the PID setting. Any advice on this is much appreciated!
Using latest firmware and gui...how can we set follow mode? i'm using 2 alexmos boards, the 2nd for yaw. please help on any instructions...the new gui doesn't have follow 100%. it's really confusing compared to the previous gui. best regards, larry
Look at my BLOG on DIYDrones.com, under Dave Beaty, I have a detailed video with settings for Follow Mode and Joystick Mode. Also find Alex's video on Youtube, he shows how to setup follow mode. In the Follow mode GUI tab you should have Follow Pitch or Follow Yaw selected and a deadband around 5 degrees. The I in the PID controls speed. Mine is around .2 or .3 for turning corners or rotating around a subject.