EN CN
Standard servo instead of the bldc motor to drive the gimbal
  • dano
    Hello,
    My hardware is: DYS Basecam SimpleBGC 32Bit (Board version 3.1) with firmware 2.63.b0.
    My question is you can configure the board to use servo instead of bldc motors?
    I know pros and cons of both drives but simply standard servo is better for me.
    :)
  • AOPEN3434AOPEN3434
    NO! if you need servo controller you can use flight controller the support servo gimbals
  • dano
    Okay, I will do that. It's a pity, because it was a cool feature sometimes. Thank you for your answer
Add a Comment