EN CN
DIY Beholder control via bluetooth: which module is installed?
  • fullscale
    ciao,

    I have a beholder DS2A, I would like to control it via Bluetooth without a smartphone (it has too short a range). I found this
    http://www.analogx.com/contents/articles/motion-controller.htm
    I bought the components and built the circuit. But I can't connect to the gimbal.
    Looking at the interface (SimpleBGC32 v2.63 b0), at "board"> "configure bluetooth ...", I don't understand which bluetooth module is installed on my gimbal.
    From the app (on Iphone or android) I can send the commands to the system.

    How can I do to understand which bluetooth module is installed?

    P.S: I'm sorry for my bad english (i will improve it...)
Add a Comment