EN CN
Frame imu fried?
-
Hello there,
i have a dys basecam 32bit with camera imu and frame imu, over 3x4108 motors.
All was working fine, but the connector on the frame imu unsoldered. So i soldered the cable directly on the pads of the connector, but i think that something was wrong, the red ligh on the imu is on, but in the buy i see that the arrow on the monito are continusly spinning around, and the calibration is no more possible becouse all the stripes jump everywehere.
Its possible to replace the originale frame imu with 1 of this? https://www.amazon.it/dp/B0734XS3V3/ref=pe_3310731_185740161_TE_item
they are for arduino, but its a similar shaps with the same chip mpu6050, so i think its can be ok....right? -
Hello,
If your board can't get data from IMU, try to check this: http://ybex.com/d/8bic62798dwvgkesxjv5kx8m7d5e8hnzx9cx9ha8.html
This is inductive filter: https://www.murata.com/en-us/products/productdata/8796743204894/ENFA0008.pdf
On DYS board, it can be located elsewhere or replaced with separate items. -
sorry for the late reply, but i bought 3ximu linked in my 1st post. They are working weel, and its possible to change the addres(frame imu or camera imu) just soldering a wire.
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!