EN CN
Proper Placement for SimpleBGC 32-bit Tiny Revision B
  • diegot
    As you know, the Tiny version also acts as the Frame IMU. I am building my own frame and was wondering if where is the optimal placement for the board to go. I would normally place it out of the way on top of the YAW motor but is that a good idea in this case?

    Any help is greatly appreciated.
  • Garug
    It should be parallel to the gimbal axis and well installed on solid place. On small gimbals it is easier to install it above yaw, on bigger gimbals installing it below yaw makes the cabling simpler.

    I have never used IMU above yaw, always below yaw, but that does not mean anything.
  • diegot
    Would right above the yaw motor be an acceptable placement?
    Like so...
    https://goo.gl/photos/bVN5c3igLDAxCZoz9

  • Garug
    Yes, then the frame IMU needs to be configured above Yaw.
  • diegot
    Thank you for your help. I will let you know how it turned out.
Add a Comment