EN CN
RC_Roll pin mode Sum-PPM / s-bus working with Frsky?
  • dominik
    Hello everyone.
    I try to add a RC Controller to my working gimbal.
    Therfor I want to use a FrSky DHT DIY transmitter and a D4R-II receiver. The output of the D4R-II is CPPM.
    The ppm signal is generated by an arduino nano and I shoud be able to set the pwm to the settings which work with the alexmos board.
    What are the ppm settings of the alexmos 32 bit board. and is this CPPM supported ?


    Thanks Dominik
  • Garug
    PPM works fine, I do not know what CPPM is. no special settings, just standard PPM. There is many Arduino libraries. I suggest using SBUS with Arduino, less error.
  • VascoSampaio
Add a Comment