EN CN
Inductor chipped on 32bit board. Is this ok?
  • cmanley
    The inductor on my 32bit board has a piece of iron chipped off the top as can be seen at the bottom of the photo below:
    http://i57.tinypic.com/2lkpafb.jpg

    Will that affect the function of the inductor and the performance of the board?
    If so, could you please let me know the value of the inductor so that I search ebay for a replacement.
    What is the inductor used for b.t.w.?
  • AndrewSupport
    Hello,
    Please, check the Voltage on 5V line. If it less than 5V, contact with your seller for exchange the controller.
    If there are 5 Volts, you better not to load that line over 500-700 mA.
    If you want to replace the inductor, contact with your seller.
Add a Comment