effrank

Can I calibrate Encoders with gearing between motor / frame?
Update: Now I read that the "Angle to move at calibration" should be set to 40 After resetting this angle the roll axis calibration seem to work. But when it changes to Pitch it is interrupted.

Comment by effrank June 2020 permalink
Can I calibrate Encoders with gearing between motor / frame?
Update: I found out that my motor to frame gearing ratio in fact wasn't 0.6 but 1.6 (I was working with the frame to motor ratio) but still have the same problem. The encoders calibration of el field results in the error message.

Comment by effrank June 2020 permalink
How many Poles? GB PM 4315
Thanks AOPEN. But I am still not sure if 14 poles is the right answer. Gimbal is shaking like hell and never finds it's level, even with lowest PID settings and perfect balance. By the way basecam GUI autodetects between 40 and 70 poles. What&#…

Comment by effrank June 2020 permalink
Use of linear PWM Encoder AS5311 instead of rotary AS5600 and readout buy the GUI
To have the device pointed in the same direction during start is not a big issue. Would you be able to implement my linear encoder? I tried to enter the value 192 in the motor / encoder gearing ratio. The value is accepted but still the readings in…

Comment by effrank June 2020 permalink
Resetting Tilt Angle by touching a button without interfering by hands
Oh great, thank you and forgive me my ignorance. I am new to BGCs and wasn't aware of the options of the adjustable variables. Hopefully your solution from 1) will do the trick fast enough (which means instantly) by scripting a change to FOL…

Comment by effrank March 2019 permalink
Resetting Tilt Angle by touching a button without interfering by hands
Hello Aleksey! I didn't know that BGCs aren't changing their angle when switched back to follow and change the home position instead. That's great news!! I have another 2-3 questions: 1) Can I write these two commands - switch to L…

Comment by effrank March 2019 permalink
Resetting Tilt Angle by touching a button without interfering by hands
Really? Nobody with experience can give me a hint? Yikes....

Comment by effrank March 2019 permalink
PWM Encoder Output Type
Maybe I should point out the encoder I want to use: It's all about the RLS AKSIM Encoder https://www.rls.si/en/products/rotary-magnetic-encoders/absolute-encoders/aksim-rotary-absolute-encoder-module I see in the extended manual that some RLS …

Comment by effrank March 2019 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

About

Username: effrank
Joined: March 2019
Visits: 17
Last Active: July 2020
Roles: Member