blacktophat

SimpleBCG v3.0 32bit board pinout request.
SOLVED, firmware issue

Comment by blacktophat April 2018 permalink
MONEY OFFERED FOR HELP
SOLVED, firmware issue

Comment by blacktophat April 2018 permalink
wtf happened?
FINAL UPDATE! Thank you to everyone who commented or reached out personally, to @AndrewSupport and the basecam team. Andrew sent me the 2_63 FW file with my SN embedded and she works perfectly now, so far as I can tell. Battery issue is resolved as …

Comment by blacktophat April 2018 permalink
wtf happened?
Also I'm not sure where or what I would enter for battery type??? It is a: Anypower T-Power 7412 Li-Ion 3.7v 10400mAh output 7.4v/12v 2A

Comment by blacktophat April 2018 permalink
wtf happened?
Anytime I write to the board I get error: Something goes wrong when writing parameters: -No confirmation on writing parameters for command 22 -No confirmation on writing parameters for command 34 -No confirmation on writing parameters for command 6…

Comment by blacktophat April 2018 permalink
SimpleBCG v3.0 32bit board pinout request.
I have emailed them to you sir! I don't know how to post them here..

Comment by blacktophat April 2018 permalink
wtf happened?
UPDATE: Varavon pulled through and connected via teamviewer and spent about an hour and half adjusting and running diagnostics. The controller is not distributing power to the motors. Battery is fully charged and powers the controller. All lights …

Comment by blacktophat April 2018 permalink
wtf happened?
update: basecam support is making me a FW file with my board SN number. I will keep this updated as I progress...

Comment by blacktophat March 2018 permalink
wtf happened?
FW 2_59b1 is currently installed. I have tried to calibrate the IMU but it says frame IMU is disabled. I can calibrate the sensor but I have no controls or anything. I am getting a license invalid error as well as "no confirmation on writing pa…

Comment by blacktophat March 2018 permalink
wtf happened?
I have tons of pictures, what do you need to see? nothing broken on the board that I can see... From what I understand the basecam boards are opensource DIY based... can I not just start all over from scratch? it worked fine before all of this, just…

Comment by blacktophat March 2018 permalink
GUI is not downloading firmware! Stuck on 0.00 firmware...
any update on this?? same issue here (among many other things)

Comment by blacktophat March 2018 permalink
wtf happened?
BUMP - Can anyone help? terms like "encoders" are getting thrown around, my encoders are disabled with about 10 options from each drop down, frame IMU is disabled, I recovered the board from a backup file and loaded the EEPROM that varavon…

Comment by blacktophat March 2018 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

About

Username: blacktophat
Joined: March 2018
Visits: 3
Last Active: August 2019
Roles: Member