pompecukor

2 axis gimbal, startup problem, if pitch postition is < -90 before startup.
Ok, but do you have any solution for our problem? I tried what you said and it did not help. Again as you see in the video, the problem is (not just start up, but also if I move with RC receiver) that if the camera pitch more than 89-90 degrees down…

Comment by pompecukor August 2017 permalink
2 axis gimbal, startup problem, if pitch postition is < -90 before startup.
Thank you again. If you like I will make another video to show you the settings, I changed to pitch roll yaw and same problem at startup. It seems to want to keep the camera not to flip picture.. "If target is to lock camera to a point on a …

Comment by pompecukor August 2017 permalink
2 axis gimbal, startup problem, if pitch postition is < -90 before startup.
Video: https://youtu.be/TI5xUHdPgxQ

Comment by pompecukor August 2017 permalink
2 axis gimbal, startup problem, if pitch postition is < -90 before startup.
Ok, I checked, ordet was roll, pitch yaw. I changed to pitch-roll-yaw, but this did not help. I will make video.

Comment by pompecukor August 2017 permalink
2 axis gimbal, startup problem, if pitch postition is < -90 before startup.
Dear Alex, I am so happy that you took time to reply. Thank you. For second question (request) answer is "yes/correct". Would like a toggle button (5pcs) for quick switch to profile on the board during setup. About original issue and…

Comment by pompecukor August 2017 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In Apply for Membership

About

Username: pompecukor
Joined: August 2017
Visits: 7
Last Active: October 2017
Roles: Member

Powered by Vanilla