slidecam

Pitch Drift
That's it! Garug, your the best! Did spend the whole evening looking for a reason but didn't think of the joystick!

Comment by slidecam January 2016 permalink
Yaw follow jitter
Hi! Sorry for the late answer. Was pretty busy the last days. Today I tried to increase Power till the motor gets warm. Tried autotune and after 5mins had some values with I = 0.00 -> didn't work out. When using a desoldered PS2 controller j…

Comment by slidecam March 2015 permalink
Camera angle off and tilt feature not working...
There is a manual in the download section. I would recommend you reading it to understand how your controller is working. I think your problem is wrong assigned channels in the RC tab.

Comment by slidecam January 2015 permalink
I2C Errors
Solved it by cutting the cable in two halfes and twisting one signal line with power cable and the other signal line with ground cable. even tested a 80cm wire and it worked!

Comment by slidecam January 2015 permalink
I2C Errors
Hi! I managed to get the 2nd IMU working. But only with a very short cable... as soon as I use a longer (30cm) cable, I get too many I2C errors to use it. It doesn't matter if I use the original one or other ones (the originals work fine, I jus…

Comment by slidecam January 2015 permalink
I2C Errors
Some additional info: When I connect only one Sensor (I2C addr 68 or 69) all sensors work! I have already tried to reflash the firmware -> no changes. Is it possible that there is a hardware issue?

Comment by slidecam January 2015 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

About

Username: slidecam
Joined: January 2015
Visits: 2
Last Active: January 2016
Roles: Member