deinspanjer

DYS Smart GoPro BL 3-Axis Gimbal
The I2C errors went away when I had a flight battery plugged in. 5V USB just wasn't enough for the board plus three gimbal motors. I'm sticking with the 2.3b5 firmware based on what you said and what someone else repeated about the later…

Comment by deinspanjer August 2014 permalink
Yaw limits don't function under RC control - 2.40b7
I'm running with 2.3b5 which is the firmware the DYS Smart-3 gimbal shipped with. I am able to get the YAW configured to angle mode fine, but my issue is that you cannot change the min angle for yaw from -45. :/

Comment by deinspanjer August 2014 permalink
8 bit vs 32 bit control boards
Are you sure about this? I'm using the 8 bit software to communicate with the BaseCam that was installed on my DYS Smart 3 gimbal, but the board has three motor outputs. It only has four sets of input pins though, FC-R, FC-P, RC-R, and RC-P. …

Comment by deinspanjer August 2014 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In Apply for Membership

About

Username: deinspanjer
Joined: July 2014
Visits: 4
Last Active: August 2014
Roles: Member

Powered by Vanilla