sb10

Firmware 2.4 woes
Thanks for all of the advise...things started out shaky and then fell in place with super high "d" and low "i". (3) x 5108s (belt drive yaw)

Comment by sb10 February 2014 permalink
Firmware 2.3B5!
This firmware upgrade is awesome, thanks!

Comment by sb10 November 2013 permalink
Bad soldering
I have the newer board that you have, I just RMA'd it to the seller who will test it to determine hardware v user error. Hopefully working after. Thanks for the advise and I'll post followup later this weekend.

Comment by sb10 October 2013 permalink
Bad soldering
Thanks mbprod, I would say it's similar...not as erratic. Did a new 3rd axis board solve your issue? Pitch and roll have been removed from test video (slow upload) at http://youtu.be/USU7zXTC4EI

Comment by sb10 October 2013 permalink
Bad soldering
Hi, and thanks for the great work... in regards to the statement, ... "Checking that hardware is ok, is simple: remove motor from gimbal, set I=0.01 and turn sensor from original position. Motor starts to rotate. If wrong winding or one on 3 …

Comment by sb10 October 2013 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In Apply for Membership

About

Username: sb10
Joined: October 2013
Visits: 12
Last Active: February 2014
Roles: Member

Powered by Vanilla