RyanThomas

V3.1 Brushless Camera Mount Gimbal Control Panel Controller
don't buy crack versions

Comment by RyanThomas September 2013 permalink
How to use software on Apple Mac???
just google FTDIUSBSerialDriver Mac older boards SiLabsUSBDriver Mac newer boards

Comment by RyanThomas September 2013 permalink
How to use software on Apple Mac???
You just need the mac drivers!

Comment by RyanThomas September 2013 permalink
Flashing board with new firmware for MAC users
running the .jar file is exactly how I am doing it!! Works fine for settings but not for flashing new firmware

Comment by RyanThomas September 2013 permalink
follow mode - how to?
I got mine to work with an I setting of 0,5 follow on 100% and Speed on 45

Comment by RyanThomas July 2013 permalink
hand held 3-axis low-down rig
How much is crazy money? What would you pay for a ready made solution?

Comment by RyanThomas June 2013 permalink
Not able to load v2.0 firmware hex file into SimpleBGC
This is normal Xloader says upload failed, but the way to check if it has been successful is the board should reboot after the flash, it it does upload was successful

Comment by RyanThomas May 2013 permalink
Naza vs Rx Connection to SBG Controller
So does this mean no camera follow POI, MK feature that allows the gimbal to follow/track your iphone/GPS?

Comment by RyanThomas May 2013 permalink
High Pitched Squeal
OK I get the high pitch squeal now! just the update frequency that will be able to be set in the new GUI.

Comment by RyanThomas April 2013 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

About

Username: RyanThomas
Joined: March 2013
Visits: 42
Last Active: September 2013
Roles: Member