yes, i am doing the motor rotation, but alway have the same error on both can driver. Also i try to READ FROM MODULE but have a message: Error reading parameters: no answer on comand. Maybe it is a motor problem? What do i need to check? Thanks.
What devices are connected to the system except CAN_drv module and CAN_MCU board? What firmware uses CAN_drv module? Go to Firmware upgrade tab of the GUI -> Connected modules -> Refresh. And in drop-down list of connected CAN modules, find CAN_drv, firmware version will be indicated there: frw.ver #
Are the motor windings connected directly to CAN_Drv module motor plug?
Also, please send place here a link to specification of using motor.