I have redone the calibration for this handheld 3 axis gimbal several times but i cant seem to get the persistent rotation to stop. it is not a quick rotation but as soon as the gimbal is given power the yaw motor slowly begins to drift, turning to the left. it takes a few minutes before making a turn about 60 degrees. is there any issue that may be causing this besides calibration? gimbal is completely stationary when calibrating. i also use a 6 side leveling cube when calibration for accuracy the gimbal. i have also tried ferrite rings both on and off. these are just some options for fixes i have tried. is the minor drift suppose to be there?
Hello, The IMU data can slowly drifting in case of temperature change. But in your case, it's unnormal drifting. Try to use "Skip calibration and use saved data" here: http://ybex.com/d/4yilf7mm1sq4x23228wid9q6fchojic1yw89zqzz.html And re-calibrate Gyro as best as possible. Repeat the test.