Can't do bode analysis
  • Whenever I try to run a test from the Analysis tab, I get the error: No response on the CMD_BODE_TEST_START_STOP command. Then the gimbal seems to do a low amplitude sine sweep, but I can't get the results.

    Details: 2 axis gimbal, v2.68 b6 with PWM Encoders.
  • More info. This problem happens with a SimpleBGC32 with firmware 2.68b w/ Encoders. I´ve just purchased a SimpleBGC32 Tiny and it has the same problem with 2.68b.

    How can I troubleshoot this?