I am getting no output in the GUI from my ROLL and PITCH encoders for my gimbal. I checked with an oscilloscope, they are outputting signals and have power.
I have tuned the gimbal with the encoders OFF, and the gimbal works as it should. When I enable the encoders and perform calibration, the gimbal does not work as it should and won't level itself. The encoders DO NOT show any data in the Monitoring tab of the GUI.
Here is my setup:
Board: SimpleBGC 32-bit Extended Controller version 3.6 GUI: v2.63 b0 Encoders: AS5048A (PWM) hooked up to FC_ROLL and FC_PITCH Pitch: GBM2804H-100T Roll: GBM4108H-120T Yaw: None IMU: 2x CAN IMU