EN CN
Yaw Encoder problem
-
I have a problem with the Yaw encoder. I have everything calibrated and at the beginning it works well, after a while, I hear an alarm and the YAW encoder that is on the clock, I figure that it goes to the left.
https://photos.app.goo.gl/TFnm4s8dXtxJ2a8t6
What can be? -
Hello,
Are you use gimbal only with YAW encoder?
Did you try push "request state" button on Debug tab when the problem was appear? Place screenshot with result here (by dropbox.com or similar service).
Do you use RC control or something else to control gimbal? -
Capture of the first image:
https://www.dropbox.com/s/5bzb28k6as5rhxp/Captura.JPG?dl=0
capture of the second image of Debug tab:
https://www.dropbox.com/s/gitah1cm8itog8t/Captura problema.JPG?dl=0
Thanks -
Hello,
Please, place only links to your screenshot here.
"Yes, I have only the encoder on the Yaw"
- if you use only one YAW encoder, you should to use only regular firmware. Because encoders firmware require encoder on each motor. -
Previously, I had said if the normal software would work to use only the YAW encoder and they said no. It is only to test. That's why I got the license.
Direct question: Is it possible to use normal software (without paid version of decoders) to be able to use only the YAW encoder? -
Hello,
Try to check the connection with YAW encoder, if you use PWM connection type: http://ybex.com/d/cxc00rvsdsiymsnt27w4oq2psdfu0lcbjwaljtq9.html
"Direct question: Is it possible to use normal software (without paid version of decoders) to be able to use only the YAW encoder? "
- yes, about this is written in the manual: http://ybex.com/d/j390ifojled9u9fgjii245wnm9qg6gb4rpx3z0vv.html
This page from here: https://www.basecamelectronics.com/files/v3/SimpleBGC_32bit_manual_2_6x_eng.pdf
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!