I have a problem with the Yaw encoder. I have everything calibrated and at the beginning it works well, after a while, I hear an alarm and the YAW encoder that is on the clock, I figure that it goes to the left.
Hello, Are you use gimbal only with YAW encoder? Did you try push "request state" button on Debug tab when the problem was appear? Place screenshot with result here (by dropbox.com or similar service). Do you use RC control or something else to control gimbal?
Yes, I have only the encoder on the Yaw Yes, I also have the RC repeater I will inventigate with respect to the "Resquet State" tab since I never use it before.
Hello, Please, place only links to your screenshot here. "Yes, I have only the encoder on the Yaw" - if you use only one YAW encoder, you should to use only regular firmware. Because encoders firmware require encoder on each motor.
Previously, I had said if the normal software would work to use only the YAW encoder and they said no. It is only to test. That's why I got the license. Direct question: Is it possible to use normal software (without paid version of decoders) to be able to use only the YAW encoder?