Hello. I am trying to connect my AlexMos 32bit board to my MacBook, but I don't see it on the dropdown list. I have installed both drivers now, the FTDI and also the SiLabs driver. Also, I have followed the steps in the manual and created the folder with permissions using terminal. The software is running, but it does not show my board. The yellow/green usb is on, and the red LED is blinking. First, the red LED blinks fast for a few seconds when connected over USB, and then it blinks very slow.
I am using: -SimpleBGC GUI 2 63b0 -Basecam BGC 32bit board (don't have any more informations about it) -micro usb cable (no battery pluged in, right?) -MacBook (OS X 10.9.5)
I can see the following in the dropdown list: /dev/tty.Bluetooth-Incoming-P... /dev/cu.Bluetooth-Incoming-P... /dev/tty.Bluetooth-Modem /dev/cu.Bluetooth-Modem UDP WiFi (TCP/IP)
Does anybody know, what the problem might be? Wrong software version, wrong USB-cable, broken board?! Any ideas on the red blinking LEDs?