EN CN
Encoder Motor Not Working
  • asinha
    Hi,
    I am working on a 2 axis gimbal. Yaw motor is with encoder and Pitch motor without. I am using Simple BGC 32 Bit extended Controller. Pitch motor is working flawlessly but I am unable to get the YAW motor (With Encoder) working. Please help.
  • muko
    Hi!

    I have the same problem. is it possible just using an encoder (for pitch) with two axes gimbal and supporting SimpleBGC (which firmware version)?

    I need the information asap
  • AndrewSupport
    Hello,
    asinha, please, place link to your YAW motor (With Encoder) here.

    muko, there are two ways:
    - Encoders firmware - requires encoder on each motor. If your system use only two motors - requires two encoders.
    - Regular firmware - only one encoder on YAW axis.

Add a Comment