EN CN
Gimbal controller + 2.2b2 SimpleBGC Gui, no realtime data
-
I bought a gimbal (8-bit, i think), but the motors didnt't move. After some research, i found out that i could use SimpleBGC to tune it.
Downloaded the app 2.2 version, install com port drivers... Connected! But...
When move the axis, there are no changes in roll and pitch.
Also in realtime data, all values (ACC, GYRO, DEBUG) are 0. There's always a straight line...
There are 2 blue lights, one in the main board, another in the camera support axis.
I can upload and download settings, but nothing happens when i move the axis, no motor moving also.
HELP... -
Hello,
Please, send us photos of both sides of your board in high resolution.
Does the GUI indicate some errors? If yes, please make a screenshot and place here. -
I think the board is in pretty bad shape... I get no errors on GUI.
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!