I updated my Beholder DS1 to the newest firmware 2.60b1. Also I loaded the 5 factory profiles that go with the newest firmware. Suddenly the Beholder acts very weird when I switch it on. Any ideas what this could cause? I may have reset the board to default settings. If this is the problem, does anyone have the settings for the beholder ds1?
has any body been able to somehow get the default profiles. without default profiles it seems impossible to tune this DS1 gimbal. weirdly no body even answers you when you talk about default profiles. why is that?
You can setup it your self it the seller is not supporting...
But you need to perform the complete setup, just tuning will not do any good if the basic setup is wrong. (and it is wrong if you have returned the factory defaults.)
And after geting it working I would suggest saving the profiles and EEPROM. that way you can always get it back to working condition.
Unless the setup is excatly same you can not copy the basic setings from any gimbal. IMU calibration needs to be performed for each gimbal anyway even if the gimbals are identical. (and quite possibly not all DS1 gimbals are fully identical)