i'm trying to use the PWM output in the GUI to remote iris and focus on a BMPCC camera using LANC port
i have a tinyPRO board with sbus futaba receiver
i followed the manual from Basecam as it follows:
PWM Output – a mapping that allows you to pass any virtual channel, decoded from serial input signal, to special pins that can output PWM signal. This signal can be used to drive a hobby servo or IR remote camera trigger, for example. On the SimpleBGC 3.0 boards, these pins share PWM output function with other functions: Servo1 – FC_ROLL Servo2 – FC_PITCH Servo3 – RC_PITCH Servo4 – AUX1 To enable servo output on any of these pins, make sure that its not specified as RC input in the GUI. This feature may be useful if you connect RC receiver by single wire and want to decode signal to the separate PWM channels to connect other RC-controlled devices.
but it looks like that there is no signal in the ports coimng out from the board and in general it's not working