EN CN
Cant connect to card anymore
  • doud
    Hello,

    I bought a gimbal on roboshop which use one of your card : http://www.robotshop.com/en/2-axis-stabilized-brushless-gimbal-w--motor--controller-for-gopro-hero-mount.html

    My problem is that I am not able to find which one it is, there is not any name or reference on it so I can not find any documentation, datasheet or diagrams. I need to communicate with it to control the gimbal with an arduino so I need some documentation. My other problem is that the gimbal in it normal mode was working yesterday and I do not know why but today I am not able to make it work again. The red light is on but the green one never blink.

    Could you help me to find those documents ? and maybe a way to do a factory data reset ?

    Thank you.

    Doud
  • Garug
    Look up, Manuals
  • doud
    Thanks for this wonderful advice !

    If I am posting here it is because I ran trough every piece of document and I browsed Google for now 3 days without any solutions.

    The only thing I can add is that i think I just bricked the firmware and when I am trying to recover it if fails : can not connect to bootloader . (I tried with many versions of SimpleBGC and different versions of recovery softares). The only step I can not figure out how do do it is : "Close (set) FLASH jumper on board (attach jumper to 2 pins marked as 'FLASH', shorting them)" In fact, there is not any pin marked as FLASH on my card, see those photos :
    http://hpics.li/b2b66f0
    http://hpics.li/f17d1f8

    Thank you
  • Garug
    " I need to communicate with it to control the gimbal with an arduino so I need some documentation."

    I thought you where looking for the Serial API documentation.
Add a Comment