Can someone PLEASE help me! I upgraded the firmware and it went crazy... i downgraded back to the original FW and got the profiles from came tv and loaded them and its still going crazy.. i been emailing CAME TV for 5 days .. they are very very vague on helping... they send me one reply a day and its at 3am..... so its basically getting me no where... HELP!!! lol
i tried that... i tried loading the original profiles.. nothing works.. but im sure its about the settings... i dont know anything about gimbals so im stuck
The best way after a firmware update, is to erase your EEPROM first. (can be found at the top from the Gui by "Board") - After this load the profile from Came TV (without Follow Mode !) and run a Motor Auto check. - Check the Motor poles, sometimes this go's wrong during a Auto check ! - Move the Gimbal by hand and check if the movements from the sensors are OK. - If the sensors moving the right way, re-calibrate the sensors (Acc. and Gyro)