Okay so I've been pulling my hair out today because I had my Came 7000 gimbal set up perfectly with joystick and functions set.
I placed the gimbal in my car for my first professional shoot but when I took it out, attached the camera and plugged the battery in it just went crazy beeping and a flashing green light on the board. The gimbal stabilizes fine and the joystick works but it just does this crazy beeping and flashing green light. If I pull out the joystick blue wire it stops.
What has happened? Would be a difference in temperature - the car was hot when I pulled it out and started it, about 30C, but was only about 20C when I set it up that morning.
The blue wire is then on the right of "BTN" (Blue and orange). I forgot to mention the joystick only works when i change direction up down left right, but pressing the button or even hold it will not execute the set functions at all
So there is something wrong with the button or how it is connected. Depending of your button it might make a difference how it is connected, if there is common ground with other wires. it is better to use button that is not connected anywhere else than BTN pins.
It is not connected anywhere else or interfering with other wires. It was working fine a few hours earlier but suddenly starts beeping and flashing green. I tried disconnecting everything and reconnecting one by one but no matter what way I do it as soon as the blue wire goes in the beeping starts