EN CN
roll axe trouble 8bit 3axis alexmos
  • tvhelp
    I assemble 3th 3axis brushless camera gimbal and have a trouble which I not see before. Everithing is OK but roll axe doesn't work. I think main plate is broken. But may be someone give me know
  • tvhelp
    just now received explanation form factory and they say that it their problem. Be careful - I think it could be a huge party(((
  • Garug
    So is the motor broken? do you have a multimeter? you could measure the motor. there should be about same resistance between each 3 wires.

    Have you configured the Roll axis on the advanced tab?

    If you perform the Motor configuration auto, does the Roll move?
  • zyler
    I have the exact same problem.
    Did you ever find out what was the problem?
Add a Comment