EN CN
Gimbal motor wire hookup help
-
I bought the iflight 2212-80t brushless motors and the GLB v3.1 board. I was able to program the board just fine. Problem is the motors have 3 wires and i dont know which way they go. they arent marked. WHichever way i hook them up they go beserk when plugged in. Any help would be appreciated. I've tried contacting ipower but no response yet.
Thanks -
Any way is fine. Just perform the motor configuration auto after connection.
-
OK i have them all hooked up but when i apply power to the board the motors go beserk and just shake like crazy. when i try to move by hand to help level they just shake.
-
heres a video. any help would be appreciated I've been working on it for several days now
https://youtu.be/U66b-KPiv9M -
That is totally expected. The camera must be installed and well balanced, the basic setup and tuning must be performed before the gimbal will work. See the users manual.
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!