EN CN
Yaw question
-
Hi.
When I turn on the gimbal the yaw not start. It start after 2-5 minutes. Do you know why? -
What gimbal do you use?
-
Hobbyking turnigy gimbal wiyh alexmos 2.40 v.2 8bit
-
sorry, alexmos 3.0, this http://rctimer.com/product-963.html
-
what firmware i need for my controller alexmos?
-
somebody can help me?
-
your board is an 8bit one. http://www.basecamelectronics.com/downloads/8bit/
-
I know my board is an 8bit.
Somsbody know why the setup start after 3-5 minutes when i power on? The roll and the pitch start immediately.
I'm uzing a es lipo, maybe i need a 4s?
Can i use a 18 volt battery drill for test? -
I'm using a 3s lipo
-
The yaw shouldn't move. What do you mean by “not start”?
Have you tried looking at the firmware settings to see if something's wrong?
You could post a video for us to see what happens exactly. :)
Before anything, you may want to update to the last 8-bit firmware, 2.40 b7. -
I use yet 2.40b7.
The yaw doesn't setting in tune when power on.
I need component schematic, somebody knows where i can find it?
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!