I am new to all of this and I have made a mistake while trying to get my gimbal up and working.
I have a GLB V3.1 2 Axis gimbal and when i tried to connect it to the 2.43b9 GUI that I downloaded it said that it couldn't connect because there was a type mismatch between the firmware and the GUI. So I then tried to upgrade the firmware so that it was the same type. Finding that I couldn't use the auto option, I did it using the manual option and used the Simplebgc_32bit_recovery.hex file that was in the firmware folder as part of the GUI download. Since doing that I cannot connect the gimbal to the GUI via the COM port. I can see it as available, but when I try to connect it just gets stuck trying to connect. Obviously whatever firmware I tried to use was wrong, and I was hoping there was a way to just restore it all to factory settings, but I can't find a way to do that.