EN CN
Names of plug connectors on latest Basecam 32bit boards?
-
Does anyone know the actual names of the white connector plugs on the latest Basecam boards? I think the IMU ports are Micro-JST connectors? However, I'm not sure what the power connector is or the Yaw, Pitch & Roll connectors?
-
Hello,
IMU connector on the boards: TE 1734709-4
http://www.digikey.com/product-detail/en/1734709-4/A99957TR-ND/2077864 -
The cables for my 3-Axis 32bit ARM BGC Controller to IMU's have slightly different size connectors at each end.
My controller board: http://www.aliexpress.com/item/NEW-ArmBGC-4-5-BT-32-bit-Alexmos-Gimbal-Controller-3-Axis-Brushless-Gimbal-Stabilizer/2047081321.html
The connectors on the circuit board are JST 2.0mm PH 4-Pin connectors, as shown here:
http://www.ebay.co.uk/itm/10-Sets-Micro-JST-2-0-PH-4-Pin-Connector-plug-Male-Female-Crimps-/171361716294?pt=LH_DefaultDomain_0&hash=item27e5f44846
The connectors on the two IMU's are JST 2.5mm XH 4-Pin connectors, as shown here:
http://www.ebay.co.uk/itm/JST-2-5-XH-4-Pin-Connector-Plug-Wire-x-10-Sets-/171346705553?pt=LH_DefaultDomain_0&hash=item27e50f3c91#ht_3178wt_1148
All info can be found for these connectors on Wikipedia here:
http://en.wikipedia.org/wiki/JST_connector
Hope this helps anyone who plans to disconnect their IMU cable connectors to fit though the motors!
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!