Connecting IMU sensors on came7000

Pettermannen

Hi! I have the came 7000, 32bit version. Is it possible to connect booth IMU sensors indvidually to the board?
As i have it now.,the Cam IMU is connected to the Frame IMU. The Frame IMU is then connected to the board.

best regards
mvh

AndrewSupport

Hello, yes, each sensor can connect individually to the board, because each sensor has his address.

Zakris1

How do u connect the imu individually to the board?

AndrewSupport

Hello, please, send photo of both sensors and control board on one snapshot.

misterl

Thanks so much everyone! I figured it out!

I hadn't cut the ADDR bridge on the back of the sensor to properly set the frame IMU address to 0x69. Once I did that, the software recognized it with no issues.

Now to see if I can finally figure out how to get this rig working!

Thanks again!

Howdy, Stranger!

Categories