EN CN
SimpleBGC POWER settings
-
What is the ideal value of POWER to be used with 5208 motors?
-
depends on the motor turn and axis but usually 100 to 200
-
I am using 200 on the 3rd Axis 200 on the roll and 150 pitch. Is this too much or whithin the normal values?
-
sounds ok are you having problems?
-
The problem I have is the roll when I pan starts to drift and takes ages to go back to level. It compensates but from 10 degrees to 0 takes about 15-30 seconds to be totally levelled again. I am lost on this one...
-
hello,
can you post your pids please -
14-0.35-20 200
4-0.26-10 150
20-0.08-15 200
I think this firmware is not very stable....I never know when the gimbal will start ok. The features of the board + firmware are nice but not stable...Do you have te same results? -
I switch back to previous version of firmwear
-
To which one?
-
2.2B2 give me better results
-
Ok Thanks I´ll try to go back too.
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!