EN CN
Help for my Gimbal
  • VALECCE

    I need help, I can not find the pid of this gimbal :-(

    AlexMos 3-Axis Gimbal Brushless Controller
    PURCHASED FROM http://www.rctimer.com/product_963.html

    + ENGINE
    iPower Gimbal Brushless Motor GBM5208-150T


    Does anyone have this setup?
    Can you give me your pid and try to copy them!
    thanks
    my email VTENUZZO@HOTMAI.IT
  • dbeaty2dbeaty2
    Hi, mine is similar. Depends on load of camera and you need perfect balance and good ACC calibration.

    Then from defaults, more power to YAW. 150-200. ROLL and PAN power 75-150. PID 10-15/ .1-.3/10-30 for a Canon DSLR with prime lens.
  • VALECCE
    Thanks for the help friend for pid.
    But now I have another problem that I can not understand-
    the numbers of the CYCLE TIME counted and then crashes.
    Then begins again and lock yet :-(
Add a Comment