I have installed a APM 2.5 and connected a 8bit board BGC (Software Version 2.30b5) on the APM CH10 (pitch) and CH11 (roll). In the BGC GUI "REAL TIME DATA" I can see that EXT_FC_ROLL and EXT_FC_PITCH getting the PWM from the APM. At the APM I use the RC CH6 for active pitch manipulation and it goes out on CH10. If I change the CH6 PWM on my RC I can see that on the BGC GUI in the "REAL TIME DATA", but the pitch will not turn.
Under RC SETTINGS I have LPF and SPEED tested from 1 to 15 and ANGLE MODE is active.
Dose anyone have a idea why the pitch will not turn?
Hm.. I try to use the PTICH with the EXT_PITCH-PWM comming from the FC, but it dose not work. Now I have the PITCH on RC_PITCH-PWM direct from the RC reciver and it works.