When I start, roll is slightly off 1 or 2 degrees. Would this be a positional problem with the IMU? I'd like a way in software to off set center on all axis (feature request)
On Yaw motor, when I power on, the motor jumps to what I assume is a magnet. Problem is it's off center with handle 20 degrees to the left or right. I have a high P setting (200) to hold motor YAW, but is there a way to fix this, other than rotating the motor mounts?
Is it possible to engage with any other users or any of the developers on this forum/website? Hello? Is anybody out there? Perhaps I need to use Google translate? That is OK.
Может быть, мне нужно использовать Google перевести
Hi... I glanced at this but can't specifically assist other than to say can you change the topic to related to the need... "two questions' is likely to be overlooked.