EN CN
Follow mode not following at all.
  • photopop
    Hi guys.

    I have a strange problem, I have the new 32bit board along with 2 IMU´s. Camera IMU is placed right under the camera and the Frame IMU is placed on top of the YAW motor (about 10cm away from it). Now everything is calibrated on all six axis and my handheld gimbal is somewhat stable apart from a small drift during operation. I might add that its a Canon 5D Mk3 that is mounted on it.
    My problem is that I am trying to program it to be in follow mode on one of the profiles but even though I have turned follow on in Roll, Pitch and YAW there is absolutely no reaction happening, its like I have not turned it on at all...!? Anybody tackled this problem in the past? I think I have enough power set to the motors, at least enough to give some sort of movement.

    any help is greatly appreciated.
  • photopop
    Damn I feel stupid.. I totally overlooked that its speed parameter was set to 0. Its working now.
  • OctovisualsOctovisuals
    No problem, mate, don't worry.

    Thanks for explaining the solution. It may be useful for someone.

    Best regards.
Add a Comment