EN CN
Longer than normal for my 2 axis controller to boot
  • buzzard
    It takes my 2 axis a alexmos controller about 5 minutes to boot before it activates the the gimbal motors, beeping the whole time.
    It has firmware updated,good power source and no error messages.
    Running BGM5108-120T motors.
    Once it starts, everything functions well outside of a little fine tuning I need to do on the Roll.
    Thanks for any feedback regarding this.
  • Garug
    If you skip the gyro calibration at startup, does it affect this?
  • buzzard
    O ,
    Do i have to calibrate gyro every time i power up ?
  • Garug
    no you don't need to calibrate at every startup, you can use the 'skip the calibration at startup' selection.
  • buzzard
    Yes it still does it if I skip gyro calibration,
Add a Comment